The spacers a run of Skadis panels hangs on straight from the wall studs, 21 mm off the wall. Their pegs fill the panels' slots, and each fixes to its stud by a #8 screw through a slot and its peg, or by countersunk screws the panel then hides. Seam spacers join two panels; end spacers hold a free edge.
| Pieces | 0 |
|---|---|
| Screws | through the pegs, a #8 with a fender washer through each panel slot, threading through the peg and spacer: a #8 × 2½ in into the stud where the peg is on the stud's side, and a #8 × 1 in into the spacer alone where it is not. Hidden, two #8 × 2 in flat heads through the spacer's countersunk slots into the stud, the slots giving 2.6 mm either way, and a #8 × 1 in with a washer in each peg |
| Screw reach | a long screw goes within 10 mm of its stud's centre: a seam within 20 mm of its stud puts the stud-side peg |10 − s| mm off it, and panels in 40 mm widths put every seam there; an end spacer's column, 20 mm from the next, is within 10 mm of the end stud. Seams near 10 mm off their studs leave the most margin |
| Fitting through the pegs | thread an end and a seam spacer onto the first panel with long screws, part way into the pegs over the studs; level the panel on the wall and drive them home; add its other spacers the same way; hang the next panel on the seam spacers' free pegs, long screws where a peg is on the stud's side and short ones elsewhere, then add its own spacers; repeat along the run |
| Fitting hidden | mark the spacers' places on the wall; screw each to its stud through its countersunk slots; hang the panels on the pegs and fix each peg with a short screw and washer. The two mix: hidden screws to place and level the first spacers, through the pegs for the rest |
Sizes are the design's defaults. Most dimensions can be changed.
Request a QuoteCut by us by the sheet, or buy the SVG for your own machine.